Processing problem
No it isn't like that at all. I will try to explain. After processing, the spaces between each frame are clear film (apart from the orange mask.) But when they are scanned the edges which are clear on the film, naturally appear black which is normal but on a number of frames on this film 'bleed' into the subject matter on the frame itself.
I have looked at the them clearly and you cannot see this without printing of scanning. Then on a print I made last night there are dark 'blobs', very faint but definitely there which correspond to the sprocket holes on the edge of the film. You can see the 'blobs' above each of the towers and all along the top edge. The top right hand corner is also discoloured but this vanishes when the print becomes darker in the bush,.
The discolouration is very light and only significant in light areas, but it is not right and should not happen. I have spoken to Tetenal today and they have never come across it either.
|