View Single Post
  #5  
Old 25th November 2014, 09:30 AM
alexmuir alexmuir is offline
Friend
 
Join Date: Jan 2010
Location: Glasgow, Scotland.
Posts: 2,668
Default

The maximum size on the baseboard is limited by the base of the column which eventually gets in the way. Floor projection is probably best, although, as Paul says, there is the option of turning the head 90 degrees for wall projection. If you do that, make sure the condensers inside the head are fully screwed down and the retaining catch on top of the head is in place, or you'll end up with a lot of bits on the floor! I think the M601 can use a 150 watt lamp which would help with big enlargements. You should check the manual first to make sure before trying that. One other thing. If you loosen the screw that holds the head on its mounting, you can pull it forward a bit, and tighten it again. This gives a bit more clearance of the column base, but probably not enough for 20x24" prints.
Alex.
Reply With Quote